Radon Mitigation | Cuyahoga Falls Ohio | Radon Removal Service | Radon Abatement Contractor Near Me

Cuyahoga Falls, Ohio, has high levels of Radon Gas. Install a Radon Mitigation System to protect you and your family.

What Is Radon Mitigation?

Radon Mitigation or Radon Abatement is the process used to safely reduce Radon Gas concentrations in the breathing zones of occupied buildings in Cuyahoga Falls for the least possible cost and greatest probability of success.

What Is The Process Used By Radon Eliminator to Mitigate Radon?

Installation Performed the Right Way

It is easy to remove a Radon gas problem, but it requires some work.

During the initial Radon Testing phase, we look at seven key points of possible Radon gas intrusion to help us better develop a plan of action. A plan based upon the particular needs of your home to mitigate the problem correctly.

To begin removing Radon, our team will search for a quality suction point that allows easy access, is aesthetically pleasing, and will provide the best possible outcome for success.

Once we have the proper suction point located, our team will begin drilling a 5" hole into your basement slab for the deployment of the Mitigation system. After the hole is dug out, our Licensed Mitigation Specialist will decide how large the "communication pit" needs to be based on a soil sample and substrate material analysis. Having the correct dimensions of the communication pit is essential to create the proper vehicle to pull air from beneath your basement slab that guides Radon out of the house. If the communication pit is too small, it will not have enough suction to draw the Radon gas out of your Cuyahoga Falls home.

After the pit has been dug, the contractor will analyze a proper discharge point to exhaust the Radon Gas outside the home.

This part is essential in ensuring that the radon is removed and does not have the opportunity to re-infiltrate your Cuyahoga Falls home due to a poorly routed Mitigation System, which we have seen in numerous homes.

After the proper discharge point has been identified and drilled out, we can begin the pipe fitting process. The Mitigation pipe fitting process begins with sealing the pipe base that goes directly into the ground. A backer rod will fill in the spatial gap. The process is finished with an industrial-grade caulk.

After the initial piping is set, the Mitigation Specialist will choose the right pipe pathway. Then, the Radon Eliminator team will connect the PVC pipes with a chemical welding agent to secure a proper fill and ensure no leaks in the piping system.

Finally, your technician will install a ventilation fan along the pipe pathway. Installing an exhaust fan in the proper location is important to make sure the fan has enough suction to pull the radioactive Radon Gas from beneath the floor of your basement up through the entry of the piping system, all the way out of your home.

How Will You Know If The Installation Worked?

After the piping has been placed and all the other cracks and intrusion points have been filled, our contractor will re-install a Radon Testing System. This system will monitor and gauge the ventilation system for the next 48 hours to ensure it is working properly.

The last step for our team is to test the direct pull of the suction system by drilling a small pilot hole in a different section of your floor. Using a smoke pencil, we will ensure that smoke does get drawn downward beneath your basement slab, letting you know that the suction is adequate for pulling Radon gas out of your home.

After the Radon Mitigation system is installed, it will run independently without any real maintenance or upkeep!