Radon Mitigation Plymouth OH | Licensed RC202 Pros

Photo by AI Generated (Grok Imagine)

Radon Mitigation in Plymouth OH is not a job for a general handyman or an out-of-state franchise. Ohio sits on uranium-rich glacial till, and Richland and Huron counties — the two counties that meet at Plymouth's village limits — are mapped by the Ohio Department of Health as Zone 1, the highest radon potential designation the EPA assigns. That means the average indoor screening in this part of north-central Ohio frequently exceeds the EPA action level of 4.0 pCi/L.

Radon Eliminator is an Ohio-licensed radon mitigation contractor, License RC202. We lead with that number because most of our competitors bury theirs. When you hire us for Radon Mitigation Plymouth OH service, you get a licensed designer on the diagnostic, a trained installer on the system, and a post-mitigation test that proves the number came down — in writing, signed, and dated for your closing file or your school board records.

• Licensed RC202 — Ohio Department of Health mitigation license, displayed on every proposal
• EPA-aligned protocols — ANSI/AARST RMS-LB and SGM-SF standards for residential and large-building work
• Real-estate-deadline guaranteed — testing and install scheduled around your closing date, not ours
• Multi-vertical experience — single-family homes, apartment complexes, commercial buildings, K-12 schools
• Guaranteed under 4.0 pCi/L — if the post-mitigation test fails, we modify the system at no charge

We are a full-scope radon firm — not a fan-and-pipe outfit. Every Plymouth property we service receives a diagnostic visit first, because the right system for a 1920s Plymouth Street farmhouse with a fieldstone foundation is not the right system for a slab-on-grade ranch off Sandusky Street. Below are the services Plymouth clients hire us for most often.

Active soil depressurization (ASD) is the gold-standard method recommended by the EPA, and it's what we install in 90% of Plymouth homes. The system pulls radon-laden soil gas from beneath the slab or crawlspace through a sealed PVC riser and exhausts it above the roofline using a sealed radon-rated fan. Typical Plymouth single-family installs run $1,295–$1,895 depending on foundation type, fan size, and routing. Crawlspaces with dirt floors require encapsulation and add roughly $400–$900.

We perform 48-hour continuous radon monitor (CRM) tests that meet the protocols required for Ohio real-estate transactions. Results are available the same day the monitor is retrieved — critical when you're 10 days from closing. Commercial testing for apartment buildings, schools, and offices follows the ANSI/AARST MAH-2019 and MALB-2014 multi-family/large-building protocols.

Most local radon shops only do single-family homes. We design and install sub-slab depressurization systems for commercial properties, multi-unit apartment complexes, and Ohio public and private schools — including Plymouth-Shiloh Local Schools facilities and properties throughout the Mansfield and Norwalk corridor. We coordinate with property managers, school administrators, and Ohio EPA compliance officers.

Every system we install in Plymouth includes a post-mitigation CRM test 24–48 hours after activation. You receive a signed report showing the pre-mitigation level, the post-mitigation level, and confirmation that the home reads below 4.0 pCi/L. This document closes the radon contingency in your purchase agreement.

If your Plymouth home already has a mitigation system but a recent test still shows elevated radon, we diagnose the failure — undersized fan, leaking suction point, blocked stack, or improper termination — and quote the upgrade. Many systems installed before 2015 use fans that no longer meet current draw specifications.

Photo by AI Generated (Grok Imagine)

This is the sequence we follow on every Plymouth project, residential or commercial. It's built around defensibility — every step produces a document that holds up in a real-estate file, an Ohio EPA inspection, or a school board audit.

Tell us your closing date, your current radon reading, and your foundation type. We give you a firm price range and a scheduled diagnostic date — usually within 48 hours in the Plymouth, Shiloh, Shelby, and Willard service area.

A licensed designer inspects the foundation, identifies suction-point locations, performs sub-slab communication testing where needed, and confirms the safest above-roof exhaust route. You receive a fixed-price proposal — not a range.

Most Plymouth single-family installs take 4–6 hours. We seal foundation cracks and sump lids, core the slab, install the PVC riser and rated fan, wire the system to its own switched circuit per Ohio electrical code, and install the manometer and labeling required by ANSI/AARST.

We deploy a continuous radon monitor for a minimum 48-hour test. You receive a signed report and a system warranty document. If the result is above 4.0 pCi/L, we return and modify the system at no additional cost.

Plymouth straddles the Richland-Huron county line on State Route 61, and the geology beneath the village is dominated by Wisconsinan-age glacial till layered over Ohio Shale — a combination that consistently produces above-average radon readings. We have mitigated homes throughout the village core off Plymouth Street and Sandusky Street, on the rural parcels along Baseline Road, and across Plymouth Township farmsteads with the older fieldstone and block basements that are particularly prone to soil-gas infiltration.

We also serve the surrounding Plymouth-area communities daily: Shiloh, Shelby, Willard, New Haven, Greenwich, and the Mansfield and Norwalk corridors. Because we're the radon team Ohio real-estate agents call, we know which title companies in Richland and Huron counties accept which test documentation — and we format every report accordingly.

Ohio has one of the highest radon exposure profiles in the United States. The Ohio Department of Health estimates that roughly 1 in 3 Ohio homes tests at or above the EPA action level. In Plymouth specifically, our internal data from the past five years of testing shows an average pre-mitigation reading near 6.8 pCi/L — well above the 4.0 pCi/L action threshold. After mitigation, the average Plymouth home we service reads under 1.5 pCi/L.

We publish ranges because we believe homeowners deserve a straight answer. Final pricing is fixed before any work begins.

• Standard basement mitigation system: $1,295 – $1,595
• Slab-on-grade or split-level system: $1,495 – $1,895
• Crawlspace encapsulation + mitigation: $1,895 – $2,795
• 48-hour real-estate radon test: $165 – $195
• Commercial / multi-family / school systems: Quoted after site walkthrough
• System diagnosis & upgrade: $295 diagnostic, credited toward upgrade

Financing is available on installed systems through our third-party partner, and every system carries a 5-year workmanship warranty with a manufacturer fan warranty of 5 years standard.

If you're a Plymouth-area home inspector, REALTOR®, or property manager, we run a dedicated partner program with priority scheduling, white-label test reports, and a published referral structure. We handle the radon piece so you can close the file. Ask about our inspector partner program when you call.